HD Online Player (usb Ppi Multi Master Cable Driver Do)
Download File --->>> https://shoxet.com/2tyOsD
How to Download and Install USB PPI Multi Master Cable Driver for Siemens S7-200 PLCs
If you want to connect your PC to a Siemens S7-200 PLC via a USB port, you need a special cable called USB PPI Multi Master Cable. This cable allows you to program, upload, and download data from the PLC using the Step 7 MicroWin software. However, before you can use this cable, you need to install the driver for it on your PC. In this article, we will show you how to download and install the USB PPI Multi Master Cable driver for Windows 7 32-bit operating system.
Step 1: Download the Driver
The driver for the USB PPI Multi Master Cable is included in the Step 7 MicroWin software installation package. You can download the latest version of Step 7 MicroWin V4.0 SP9 from the Siemens website or from this link: https://support.industry.siemens.com/cs/document/109741799/simatic-step-7-microwin-v4-0-sp9-released-for-deliverydti=0&lc=en-WW. After downloading the file, extract it to a folder on your PC.
Step 2: Install the Driver
To install the driver for the USB PPI Multi Master Cable, follow these steps:
Connect the USB PPI Multi Master Cable to a USB port on your PC. The cable has a serial number starting with 6ES7 901-3DB30-0XA0.
Open the Device Manager on your PC. You can do this by clicking on Start > Control Panel > System and Security > Device Manager.
Under Human Interface Devices, you should see a device named USB Input Device. Right-click on it and select Update Driver Software.
Select Browse my computer for driver software and navigate to the folder where you extracted the Step 7 MicroWin software.
Inside the folder, go to SIMATIC_STEP_7_MICRO_WIN_V40_SP9 > Disk1 > InstData > Resource1.zip > Windows > Installer > Data > Disk1 > Drivers > USBPPI.
Select the file named s7epaImp64x.exe and click Open.
Follow the instructions on the screen to complete the installation of the driver.
Restart your PC after the installation is finished.
Step 3: Configure the PG/PC Interface
To use the USB PPI Multi Master Cable with Step 7 MicroWin software, you need to configure the PG/PC interface settings on your PC. To do this, follow these steps:
Open Step 7 MicroWin software on your PC.
Click on Options > Set PG/PC Interface.
Select PC/PPI cable.PPI.1 as the interface type and click Properties.
In Local Connection, select USB as the connection type.
In PPI section, set Station Address to 0 and Baud Rate to Auto.
Click OK to save the settings and close the window.
Step 4: Test the Connection
To test if the connection between your PC and PLC is working properly, follow these steps:
Connect the other end of the USB PPI Multi Master Cable to the PPI port of your PLC. The PPI port is usually located at the bottom right corner of the PLC.
Turn on your PLC and make sure it is in STOP mode.
Open Step 7 MicroWin software on your PC and create a new project or open an existing one.
Click on PLC > Connect to PLC.
If everything is configured correctly, you should see a message saying \"Connection established\". You can now program, upload, or download data from your PLC using Step 7 MicroWin software. 061ffe29dd